Autoroute Errors

Discuss PCB123. Talk to the influencers. Be an influencer.

Autoroute Errors

    by danlee58 » Wed Jul 30, 2014 5:23 pm

I have run autoroute on my design. I get a message that there are 2 errors.
How can I find where those errors occur in the design?
How can I print the netlist?
Posts: 4
Joined: Wed Jul 30, 2014 5:21 pm

Re: Autoroute Errors

    by Sal Hernandez » Fri Aug 01, 2014 7:35 am

You can go to the DRC tab at the bottom of the Edit Panel to view a list of the reported errors. Since there are only two you can press the n key to jump the next error.

You can print a netlist by selecting File > Export > Simple Netlist.

Sal Hernandez
Software Support Engineer I
Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 503-829-9108 x226
Fax: 503-829-5482
Sal Hernandez
Posts: 381
Joined: Wed Jul 06, 2011 12:00 am

Return to “General PCB123 Discussion”

Who is online

Users browsing this forum: No registered users and 0 guests