- Editing
- How do I modify the board outline?
- How do I add traces to my layout?
- How do I change trace width?
- How to set PCB123 net width and spacing
- Increasing thermal relief widths.
- How to Make Mounting Holes
- How do I add a via?
- How do I place a footprint on the bottom layer?
- How do I change trace width?
- How to route a trace at an angle other than 45º or 90º
- How do I create an internal plane layer or filled copper region?
- How do I connect to an internal plane layer or filled copper region?
- How to cut out a section of a polygon.
- How do I modify the solder mask layer?
- Can I add information to the silkscreen layer?
- Is it possible to change the board configuration once I start the layout?
- How to change your reference designator
- How to change net assignment or merge nets
- How to set the default via size
- How to change the DRC spacing value.
- Creating a Footprint with a Round Pin Array
- How to make a round PCB with (one) flat side.
- Creating a filled copper pour.
- How to create an edge connector footprint
- Netlist
- Parts Creation
- Capabilities
- How do I access the schematic capture?
- Schematic symbol does not update after editing
- Placing and Editing ports
- Box around schematic section prevents wire connection
- V4 symbol creation and library locations
- How do I make schematic symbol pin labels invisible?
- An example creating a 7400 multi section symbol
Quote and Ordering
- How do I get a quote?
- How do I check my order status?
- Can I use a purchase order for payment?
- What if I want to oder more than 100 boards?
- How to order Gerbers files from your PCB123 design
- Can I order ValueProto with my PCB123 design?
- PCB123 Manufacturing Capabilities
- Can I use your software without an internet connection?
- How long will it take to build my board?
- Commonly Used Folders and User Files
- Having troubles installing?
- Can I use a 3rd party schematic capture program with PCB123?
- How can I locate specific warnings reported by the DRC?
- Ultra Library part issues
- Schematic symbol does not update after editing
- 4.1.20 crash to desktop bug
- Standard library part error, Pin Name mismatch.
- Long wait time when trying to disconnect pin from net.
- Long wait time when trying to delete layout footprints
- Missing Rats nest line in PCB123 version 4.1.20.0
- I've purchased gerbers and my non-plated drills are small
- Netlist Importing Issues
- PCB123 crashes on start up: new or upgraded installation
- Proxy error message
- Traces snapping to other traces or pads while freestyle rout
- v4.1.25 netlist importing issue