Order on hold for insufficent clearances?

Includes information regarding protoyping, technical questions, company news, and input about our products.

Order on hold for insufficent clearances?

    by Eric Haugen » Thu Nov 29, 2012 1:20 pm

Does your order keep getting put on hold for insufficent inner layer clearances or your outer layer pads are too small and you're just not sure what this means?

Here is an inner layer clearance

Here is a outer layer pad

We have a drill table listed on our PCB Manufacturing page that shows what your pad size or clearance to your drill hole should be. Your pads should be .018" larger than the finished hole size for your outer layers and the inner layers we would like to see .025" clearance over the finished hole size (.020" for Full Feature).

As always, a list of Sunstone's [url=hhttp://www.sunstone.com/pcb-capabilities/pcb-m ... pabilities]Printed Circuit Board Manufacturing Capabilities[/url]
Eric Haugen
Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 800-228-8198
Fax: 503-829-6657
Eric Haugen
Posts: 31
Joined: Thu Sep 08, 2011 12:00 am

Return to “Products and Services”

Who is online

Users browsing this forum: No registered users and 2 guests