Can a layout Polygon be a Pin?

[Sal Hernandez]

At this point, no, you can't set a property to identify a polygon as a pin. I have already submitted an enhancement request to allow creating custom shaped pads. I will add your feedback to the request.

[dooori]

I selected a LED (598-8310 107F) using Add Part. The schematic symbol looked rather strange, so I went to the Symbol Editor and loaded it. I found an "*" shown under the Section along with a repeat of the pin number. Anybody know what this means and how to use it (assuming one would wish to use it)?

[Robert Ohanesian]

If you take a look through the manual, you'll find out that the little star "*" next to a part means that it has been edited. You can get rid of that star if you revert back to the original part.

[Robert Ohanesian]

Thank you! We always appreciate feedback from our customers. If you have any questions or any more comments please feel free to send them to our support email.

support@sunstone.com