Changing title block

PCB123 Schematic Questions and Discussion.

Re: Changing title block

    by Barbie » Sun May 20, 2012 8:40 am

To enable your edit panel so you can view these options -make sure you have a new board file started so the main schematic tab at the bottom of the sceen will be available. Once this is done, click on the main schematic tab to open the schematic page. Then go to View > Toolbars > Edit Panel make sure that is checked see photo attached:
editpanel.JPG (35.88 KiB) Viewed 7435 times
To match the image you see on page 99 of our manual which is showing The board configuration on the edit panel you just enabled. You would need to select the project tab at the bottom of the Edit panel as shown below:
projecttab.JPG (22.77 KiB) Viewed 7435 times
Thank you for your interest in PCB CAD Tools

Let me know if I can assist you further!

Barbie Dunham

Customer Support Representative
Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 800-228-8198
Fax: 503-829-6657
Posts: 14
Joined: Mon Apr 02, 2012 12:00 am

Re: Changing title block

    by Rosette Bravo » Mon Jan 19, 2015 10:17 pm

Once you create the edge connector fingers for both sides of the board place both on your design. Move the fingers for the top layer into position. Next right click on the footprint for the bottom side fingers and select Opposite Side. This will mirror the footprint and place the pads on the bottom layer of the board. You can then move the pads into position.
Rosette Bravo
Posts: 1
Joined: Mon Jan 19, 2015 10:12 pm

Return to “PCB123 Schematic”

Who is online

Users browsing this forum: No registered users and 1 guest