Here you can find discussions pertaining to finding or creating Symbols and package footprints. Anything to do with Schematic or layout parts will be placed in this discussion.
You don't need to use overlapping holes. Version 5.0.3.1 now allows you to create slots. Just add a pin and you can adjust its properties to make it a plated slot.
Regards,
Sal Hernandez
Software Support Engineer I Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 503-829-9108 x226
Fax: 503-829-5482
You can have up to 4 slots in a PCB123 order. If you go over 4 you can order the board by going to www.sunstone.com and placing your order through the Full Feature service.
Regards,
Sal Hernandez
Software Support Engineer I Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 503-829-9108 x226
Fax: 503-829-5482