Sunstone Printed Circuit Board Forum

Is there a 1" restriction on the pad width/height? I'm building a part that has a 22.35mm x 28.70mm ground pad. When a attempt to make the surface pad with those dimensions I get the error "Please enter a pad height greater than zero and less than 1 inch". What is the proposed way around this?

Thank you,
Mike

istvanb, thanks for the response. I'm actually trying to build a part and I need a 22.35mm x 28.70mm exposed pad for the ground pin on the part. I am not aware of anyway to do a copper pour that would be exposed for soldering the part on.

Any help on making a 22.35mm x 28.70mm exposed ground pad would be greatly appreciated. Thank you.

Let us know if this worked for you. If not we have a few other things you can try out. You can always email in to support@sunstone.com and let us know if you experience any difficulties.