How to create an edge connector footprint

Here you can find discussions pertaining to finding or creating Symbols and package footprints. Anything to do with Schematic or layout parts will be placed in this discussion.

How to create an edge connector footprint

    by Sal Hernandez » Mon May 14, 2012 9:30 am

Start by creating a footprint for the top side pads. Place two of these footprints on the board. Move the first into position on the top side. Mouse over the second, right click and select opposite side. This will move the second footprint to the bottom side of the board then move into position.

Sal Hernandez
Software Support Engineer I
Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 503-829-9108 x226
Fax: 503-829-5482
Sal Hernandez
Posts: 381
Joined: Wed Jul 06, 2011 12:00 am

Re: How to create an edge connector footprint

    by joseph.steve » Wed Jul 11, 2012 7:07 am

How can i add frame around the prints.I have difficulty to set the frames around the prints during printing command.So let me know that how can i add or make the frame adjustments for my prints.
Posts: 1
Joined: Mon Jul 09, 2012 7:33 am

Return to “Schematic and Layout Parts (Libraries)”

Who is online

Users browsing this forum: No registered users and 2 guests