PCB Layout Help

[minitruck]

I don't know anything about circuit layout or any parts required but I need to develop one. I need a PCB that can receive a remote signal. After the signal is received I need it to engage a solenoid to pull around 2 pounds for about 2-3 seconds. After that I want it to return to its original state. I have absolutely no clue how to do any of this or where to begin. Any help would be much appreciated!

[Robert Ohanesian]

This sounds like you need more help than Sunstone can provide. I would recommend you try a design firm. They will be able to handle your needs a lot better. Here is a link to a few of our recommendations.
http://www.sunstone.com/pcb-support/pcb-designers