Sunstone Printed Circuit Board Forum

At this point, no, you can't set a property to identify a polygon as a pin. I have already submitted an enhancement request to allow creating custom shaped pads. I will add your feedback to the request.

I selected a LED (598-8310 107F) using Add Part. The schematic symbol looked rather strange, so I went to the Symbol Editor and loaded it. I found an "*" shown under the Section along with a repeat of the pin number. Anybody know what this means and how to use it (assuming one would wish to use it)?

If you take a look through the manual, you'll find out that the little star "*" next to a part means that it has been edited. You can get rid of that star if you revert back to the original part.

Thank you! We always appreciate feedback from our customers. If you have any questions or any more comments please feel free to send them to our support email.

support@sunstone.com