Open Thread for Parts with Errors

[Eric Haugen]

I am using the LTV-817S footprint from the Sunstone website for my PCB but when I run DRC it shows the error: One Components overlap Error. Any inputs for that?

Yes, this is not a problem with the part. You can find more information regarding the error with this thread:

understanding-the-component-overlap-warning-t279.html

[Sal Hernandez]

Thank you for reporting this issue. I have attached a library that contains the 4-SMD footprint that you can use with the LTV-817S part. You can use the SOIC_14 footprint found in the standard.slb library for part LM339ADR. I have reported the incorrect parts.

[jed]

Sal,
I am looking at the TDK part: C2012SL1A104J, which uses the footprint CC0805_53N_TDK. We built a board based on this, and we found that the parts did not really fit well, and had to do some hand soldering to update the board. I am reviewing these footprints now (all of them) and I want to make sure I am doing it correctly... For this part, how would you verify it to have the correct footprint? What i did is as follows:
1. Went to the datasheet and compared the measurements (converting metric to mils) related to the soldering instructions: http://media.digikey.com/pdf/Data%20She ... pl_B11.pdf page 70.

I found these to be very different from the footprint provided in PCB123... This is why I am asking for some help in verification. If you have time can you take a look at this part and tell me what you think the footprint should be?

I am fairly new to this development, so any help would be much appreciated.

Thanks,
Jed