Page 1 of 1

Place bus in schematic

PostPosted: Fri May 06, 2016 7:50 am
by xtaero
Please consider to add bus placement capability to the schematic. This should include multi-page buses connection. Thank you!

Re: Place bus in schematic

PostPosted: Mon May 09, 2016 2:21 pm
by Robert Ohanesian
Hello xtaero,

Can you clarify what you mean by bus? I am not familiar with that term in regards to a schematic. If you want you can email in to and we can look at your .123 file in more depth.

Re: Place bus in schematic

PostPosted: Mon Jun 06, 2016 12:44 pm
by Nolan Johnson
A bus is a group of wires representing a bit vector. Rather than drawing and/or labeling the individual wires in a schematic, you can draw a single "bus wire" to represent all of the wires.

This visiwiki page does an adequate job of explaining the concept and the schematic notation. ... _schematic

Adding a bus construct to PCB123 is on the roadmap, to be sure, but as of today (6/6/2016) has not yet been put on the developer's schedule.