Page 1 of 1

Schematic Design suggested enhancement

PostPosted: Fri Dec 11, 2015 1:09 pm
by ideaman4u
Way back in the time of dinosaurs, PCB123 Schematic Capture had a neat feature where you could create a small database of often used components accessible from a toolbar initially on the right edge of the Schematic Capture window.

For example, most of us end up using 0.1 or 0.01 uF decoupling caps or pull up/down resistors all over in our designs. Would be nice to have these oft used components easily available rather than having to either memorize or write down the lookups for these components for selection using the component tool. How about adding this to the list for version 5.2 and succeeding?

Re: Schematic Design suggested enhancement

PostPosted: Tue Dec 15, 2015 11:29 pm
by jean_howard

I like your idea of adding it to 5.2!