To enable your edit panel so you can view these options -make sure you have a new board file started so the main schematic tab at the bottom of the sceen will be available. Once this is done, click on the main schematic tab to open the schematic page. Then go to View > Toolbars > Edit Panel make sure that is checked see photo attached:
To match the image you see on page 99 of our manual which is showing The board configuration on the edit panel you just enabled. You would need to select the project tab at the bottom of the Edit panel as shown below:
Thank you for your interest in PCB CAD Tools
Let me know if I can assist you further!