Changing part footprint associations
2 posts
• Page 1 of 1
Re: Changing part footprint associations
If you are importing your netlist with changes and you do not see the changes it is usually because an error message has been presented and you have not corrected the issue. What is the error you get when trying to update your netlist?
Regards,
Sal Hernandez
Software Support Engineer I
Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 503-829-9108 x226
Fax: 503-829-5482
Sal Hernandez
Software Support Engineer I
Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 503-829-9108 x226
Fax: 503-829-5482
- Sal Hernandez
- Posts: 381
- Joined: Wed Jul 06, 2011 12:00 am
2 posts
• Page 1 of 1
Return to “General PCB123 Discussion”
Who is online
Users browsing this forum: No registered users and 2 guests