How Can I run trace with different width through a Via?

Discuss PCB123. Talk to the influencers. Be an influencer.


How Can I run trace with different width through a Via?

    by Chuan Liu » Mon Feb 18, 2013 12:24 pm

For some users that want to have different width for a trace on two different layers of the board connected by a VIA. You can not adjust the width for one trace going through a VIA to another layer. The only work around is use the add pin tool to add a pin to act as your VIA.
trace1.JPG
trace1.JPG (97.04 KiB) Viewed 5224 times
Chuan Liu
 
Posts: 22
Joined: Fri Sep 23, 2011 12:00 am



Return to “General PCB123 Discussion”

Who is online

Users browsing this forum: No registered users and 2 guests

cron