How to set the default via size

Discuss PCB123. Talk to the influencers. Be an influencer.


How to set the default via size

    by Sal Hernandez » Mon May 14, 2012 9:30 am

The smallest available holes is .02 for a double sided boards and .014 for a multi layer. There is no single location to change the default via size. You can change via size per net by right clicking on a trace or rats nest line and selecting properties. On the nets tab you can set the via size (outer diameter of the via) and finished hole size (inner diameter).


If you want to change the default via size for all nets, start by selecting the entire layout. Left click and hold outside the board outline and drag a selection box around all objects to select the entire board. Next, right click on any object and select properties. Switch to the nets tab and set the values for via size and finished hole size. This will set via size for all nets that already exist on the board. Any new nets will revert to the system default.
Regards,

Sal Hernandez
Software Support Engineer I
Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 503-829-9108 x226
Fax: 503-829-5482
Sal Hernandez
 
Posts: 381
Joined: Wed Jul 06, 2011 12:00 am



Return to “General PCB123 Discussion”

Who is online

Users browsing this forum: No registered users and 2 guests

cron