Schematic wires
PostPosted: Sat Dec 31, 2016 2:17 pm
I am using PCB123 version 5.4.1 and have noticed that after deleting a wire connection in schematic it shows back up at random when redrawing/panning the first few times then it is gone. It's not a valid connection just not cleared fully from the drawing.
Also when placing the cursor over a wire line to delete it the first wire deletes fine. When deleting the next one the screen flashes I see the one I deleted previously and have to hit delete the second time to delete the line, so I have to press DELETE twice to remove it.
Also when placing the cursor over a wire line to delete it the first wire deletes fine. When deleting the next one the screen flashes I see the one I deleted previously and have to hit delete the second time to delete the line, so I have to press DELETE twice to remove it.