Schematic wires

Discuss PCB123. Talk to the influencers. Be an influencer.

Schematic wires

    by daduggan » Sat Dec 31, 2016 2:17 pm

I am using PCB123 version 5.4.1 and have noticed that after deleting a wire connection in schematic it shows back up at random when redrawing/panning the first few times then it is gone. It's not a valid connection just not cleared fully from the drawing.

Also when placing the cursor over a wire line to delete it the first wire deletes fine. When deleting the next one the screen flashes I see the one I deleted previously and have to hit delete the second time to delete the line, so I have to press DELETE twice to remove it.
Posts: 6
Joined: Tue May 29, 2012 11:24 am

Return to “General PCB123 Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest