Can I remove all routing with one command?

Discuss PCB123. Talk to the influencers. Be an influencer.
Post a reply

Can I remove all routing with one command?

    by Sal Hernandez » Mon Dec 17, 2012 12:09 pm

More than one step is required to remove all routing on a layout but it can be done easily.
  1. Drag a box around the entire layout.
  2. Right click on any object select Route Commands > Unroute.
Regards,

Sal Hernandez
Software Support Engineer I
Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 503-829-9108 x226
Fax: 503-829-5482
Sal Hernandez
 
Posts: 381
Joined: Wed Jul 06, 2011 12:00 am
Top
Post a reply

Return to “General PCB123 Discussion”

Who is online

Users browsing this forum: No registered users and 2 guests