Sunstone Printed Circuit Board Forum

When I print a schematic in PCB123 V4, I get unwanted part names printed for some parts. The print is overlaid so it's not readable anyway but it doesn't show on-screen, just on the printout. How can I turn this off?

Thank you for the feedback. This is a known issue that will be resolved in the next release. This only happens when you make properties visible that were not visible by default. If you set the properties so that only the default properties are visible the issue will go away.You can just use the Text tool for any additional text until the next release is available.

We expect to have an updated PCB123 release early next month.