How to fix DRC "Pad to pad" error.
PostPosted: Tue Aug 21, 2012 11:16 am
PCb123's default minimun trace/space is 0.007". But if your trace's net properties set the space to other bigger number for spacing, you might get DRC "Pad to Pad" error.
This DRC error is because the Net spacing was set to 0.030". To correct this please mouse over Pin 4 's yellow ratsnest line and right click “properties”.
Then change the Spacing to something like 0.007”.
- Pad to pad.JPG (41.19 KiB) Viewed 7355 times
Then change the Spacing to something like 0.007”.
- Net spacing.JPG (22.64 KiB) Viewed 7355 times