Page 1 of 1

How to fix DRC "Pad to pad" error.

PostPosted: Tue Aug 21, 2012 11:16 am
by Chuan Liu
PCb123's default minimun trace/space is 0.007". But if your trace's net properties set the space to other bigger number for spacing, you might get DRC "Pad to Pad" error.
Pad to pad.JPG
Pad to pad.JPG (41.19 KiB) Viewed 5416 times
This DRC error is because the Net spacing was set to 0.030". To correct this please mouse over Pin 4 's yellow ratsnest line and right click “properties”.

Then change the Spacing to something like 0.007”.
Net spacing.JPG
Net spacing.JPG (22.64 KiB) Viewed 5416 times