Discuss PCB123. Talk to the influencers. Be an influencer.
I have run autoroute on my design. I get a message that there are 2 errors.
How can I find where those errors occur in the design?
How can I print the netlist?
- Posts: 4
- Joined: Wed Jul 30, 2014 5:21 pm
You can go to the DRC tab at the bottom of the Edit Panel to view a list of the reported errors. Since there are only two you can press the n key to jump the next error.
You can print a netlist by selecting File > Export > Simple Netlist.
Software Support Engineer I
13626 S. Freeman Road
Mulino, OR 97042
Phone: 503-829-9108 x226
- Posts: 381
- Joined: Wed Jul 06, 2011 12:00 am
Return to “General PCB123 Discussion”
Users browsing this forum: No registered users and 2 guests