Pick-and-place (centroid) and solder paste data?

Discuss PCB123. Talk to the influencers. Be an influencer.

Pick-and-place (centroid) and solder paste data?

    by jacobq » Sat Mar 01, 2014 10:45 pm

I want to use an automated assembly service such as Sunstone's suggested partner Screaming Circuits. How can I generate the pick & place data in PCB123?

Also, I am used to seeing layers for solder paste, but I don't see this. How can I control this? I don't want my test points (untented/unsoldermasked pins) to have solder on them...
Posts: 1
Joined: Sat Mar 01, 2014 10:43 pm

Re: Pick-and-place (centroid) and solder paste data?

    by Sal Hernandez » Mon Mar 03, 2014 7:24 am

You can email support@sunstone.com after placing your order to request the assembly files for your order. We can provide paste, centroid, and assembly layers at no charge. If you require the full set of gerbers with a board order there is a $50 charge. If you only want the full set of gerbers without ordering boards there is a $100 charge.

PCB123 automatically creates the solder paste layer using the surface mount pads on your layout. At this stage you cannot add or remove paste layer information manually in PCB123. This is a capability we are considering for a future release. Please contact customer support if you have any questions.

Sal Hernandez
Software Support Engineer I
Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 503-829-9108 x226
Fax: 503-829-5482
Sal Hernandez
Posts: 381
Joined: Wed Jul 06, 2011 12:00 am

Return to “General PCB123 Discussion”

Who is online

Users browsing this forum: No registered users and 2 guests