Thank you for your quick reply. Do you have a better idea about when you might have this feature available? The problem with deleting the current part and adding a new part is that all the routing that I did to the original part will be lost and I'd have to re-route 50 or so connections. I really don't want to have to do this. I guess as a work around I could manually add the connection on the board layout. This would then create a sync page on the schematic? While this connection wouldn't be easily seen on the schematic, the connection would be there. In the case of building new symbols, namely large pin count microcontrollers, what would you suggest?On one hand, I don't want a cluttered schematic that's hard to read, buton the otherhand I don't want to have this issue come up that is not easy to fix. Any suggestions would be great as I am pretty new at this stuff.