Dip Trace – Create NC Drill File
PostPosted: Wed Jun 20, 2012 9:49 pm
Hello,
To generate the NC Drill file from Dip Trace software; select ‘File > Export > N/C Drill’ from the main menu. The ‘Export N/C Drill’ window will open (see attached DipTrace_Export NC Drill.jpg). Press the “Auto” button to define the tools and then click “Export.”
For through holes, you do not need to select the layers. However, if your hole is a blind or buried via, you would need to select the layer(s) where the holes are located. The remainder of the selections should be set as in the example shown, with the exception of the size. If you have specific questions about this window and the correct settings, please reply to this post and we will try to locate this information for you.
But keep in mind that many products at Sunstone, as ‘Quick Turn’ and ‘Value Proto Products’, do not support blind or buried vias. Please contact Sunstone Customer Support or visit our Products Page http://www.sunstone.com/pcb-products for more information and what products are available. Or go directly to the following products.
ValueProto Printed Circuit Boards
Full Feature Printed Circuit Boards
Quickturn Printed Circuit Boards
Always use “Preview” to view the result before submitting the file. Don’t forget to confirm that the new NC Drill file matches the remainder of the files and is the same revision of the Gerber files that you generated.
Thank you!
To generate the NC Drill file from Dip Trace software; select ‘File > Export > N/C Drill’ from the main menu. The ‘Export N/C Drill’ window will open (see attached DipTrace_Export NC Drill.jpg). Press the “Auto” button to define the tools and then click “Export.”
For through holes, you do not need to select the layers. However, if your hole is a blind or buried via, you would need to select the layer(s) where the holes are located. The remainder of the selections should be set as in the example shown, with the exception of the size. If you have specific questions about this window and the correct settings, please reply to this post and we will try to locate this information for you.
But keep in mind that many products at Sunstone, as ‘Quick Turn’ and ‘Value Proto Products’, do not support blind or buried vias. Please contact Sunstone Customer Support or visit our Products Page http://www.sunstone.com/pcb-products for more information and what products are available. Or go directly to the following products.
ValueProto Printed Circuit Boards
Full Feature Printed Circuit Boards
Quickturn Printed Circuit Boards
Always use “Preview” to view the result before submitting the file. Don’t forget to confirm that the new NC Drill file matches the remainder of the files and is the same revision of the Gerber files that you generated.
Thank you!