Search found 3 matches

by Zheng Li
Mon May 14, 2012 9:30 am
Forum: Schematic and Layout Parts (Libraries)
Topic: Open Thread for Parts with Errors
Replies: 14
Views: 7335

Re:Open Thread for Parts with Errors

I used the footprint 68_PIN_SCSI_MALE (in a custom part) and received the following DRC error: Pad annular ring too small with object U1.69. Required annular is 15.0 mils. Actual annular is 4.0 mils. Thanks!
by Zheng Li
Mon May 14, 2012 9:30 am
Forum: General PCB123 Discussion
Topic: Understanding the Isolated Pin Error message
Replies: 3
Views: 3675

Re:Understanding the Isolated Pin Error message

Hi, as mentioned above, the default isolation is 0.008 for standard 1oz copper. Where can I change this setting?
by Zheng Li
Mon May 14, 2012 9:30 am
Forum: Schematic and Layout Parts (Libraries)
Topic: Open Thread for Parts with Errors
Replies: 14
Views: 7335

Re:Open Thread for Parts with Errors

<t>I ordered a board with several generic jumper (header) footprints. The through hole sizes were a tad small for the generic jumper parts I had. The problem was that the jumper header pins are square in crosssection, requiring a slightly larger hole, which would have otherwise been ok. Perhaps Suns...

Go to advanced search