Page 1 of 1

The PCB123 v4 schematic title block is gone.

PostPosted: Mon May 14, 2012 9:30 am
by Sal Hernandez
There are a few lines missing or incomplete in the pcb123.ini file located at the following location.

C:\Documents and Settings\All Users\Application Data\PCB123

Modify this block if it already exists, or append it to the end of the file:

[SchematicDefaults]
DefaultTitleBlockLib=Lib/TitleBlocks.sym
DefaultTitleBlockSymbol=TITLEBLOCK


This will display the title block for all new board files. If you have an existing file that does not display the title block you can modifiy the page size after updating the ini file to refresh the page and you will then get the title block back.

Right click on the schematic screen and select Set Page Size to change the page size.

Sal