Traces snapping to other traces or pads while freestyle rout

Discuss PCB123. Talk to the influencers. Be an influencer.

Moderator: Sunstone Moderators



Traces snapping to other traces or pads while freestyle rout

Postby Eric Haugen » Mon May 14, 2012 9:30 am

This is a known issue with PCB123 at this time. You can hold down the control key while routing your trace, and this will sometimes help the issue. If you cannot get the trace to run to the destination, go ahead and just run it to the trace or pad/pin. Then you can modify the trace to get to the correct destination or you will have to just route it from another location.

We hope to have this bug fixed soon in a future update.
Eric Haugen
Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 800-228-8198
Fax: 503-829-6657
Eric Haugen
 
Posts: 31
Joined: Thu Sep 08, 2011 12:00 am



Return to General PCB123 Discussion

Who is online

Users browsing this forum: EletlyRes, gromarryiz, Learfasse, TimothyWoure, TopImimb, UnlannaRot, Wotawomma, ZemCheva and 1 guest

cron