Search found 4 matches

Return to advanced search

Re: Updated: PCB123 Parts Creation Process

I am using a digikey part 1-282834-2 and created 12 pins for it and enclosed it with a polygon to set the outside dimensions of the part of 1.25 by 0.26 inches. I used a symbol for the schematic from another offline connector symbol. However when I layed out the board, I kept getting a DRC error of ...
by binsk
Wed May 22, 2013 11:58 am
 
Forum: General PCB123 Discussion
Topic: Updated: PCB123 Parts Creation Process
Replies: 6
Views: 82224

Re: Ground Planes

I tried using the filled polygon again.. the first time I entered a filled polygon and then did autoroute wasn't able to route anything. I tried it again, designated the layer and established a filled polygon as a ground plane then autorouted and it put protected areas around the active pins etc. an...
by binsk
Wed May 22, 2013 11:44 am
 
Forum: General PCB123 Discussion
Topic: Ground Planes
Replies: 2
Views: 7155

Ground Planes

I wanted to make the bottom layer a ground plane. Example in manual page 119 says select the edit layer to bottom layer but that is just the layers to display, then it says to click on "add board outline" icon... no mention of what icon that is.. haven't found it yet. On my board I have pl...
by binsk
Tue May 21, 2013 3:48 pm
 
Forum: General PCB123 Discussion
Topic: Ground Planes
Replies: 2
Views: 7155

Problem 6-DIP Schematic symbol

It would be handy if the library 6-DIP-300 matched the layout component
1 6
2 5
3 4
such as this. not sure if the other DIPs are the same
by binsk
Tue May 21, 2013 3:39 pm
 
Forum: Schematic and Layout Parts (Libraries)
Topic: Problem 6-DIP Schematic symbol
Replies: 1
Views: 1434

Return to advanced search

cron