Hi,

Is there a way for PCB123 to make a blinded via?

Anthony

Hi,

May I ask where the subfolder in the taxonomy go or will the folder be saved in the local drive? I have searched over the ProgramData/PCB123 folder but still no luck.

Thanks

Hi there,

I am trying to make a polygon pin for a footprint but I cannot make one using the footprint editor in pcb123. Can anyone advise?

Many thanks in advance!

Continuing from my post before, LTV-817S footprint is too small for the part. LM339ADR is also a wrong footprint that the size of the footprint is bigger than the actual component size.

Just a reference for other designers so changes can be made before moving on to PCB manufacture.

I am using the LTV-817S footprint from the Sunstone website for my PCB but when I run DRC it shows the error: One Components overlap Error. Any inputs for that?

I found several footprints that are different from the layout recommended by the manufacturer's datasheets. Therefore I was wondering if these footprints still work for the parts? Here are the lists of part numbers that are different: AU-Y1007-R AU-Y1006-R EXB-V8V153JV Any inputs are going to be acc...