Creating a Footprint with a Round Pin Array

Discuss PCB123. Talk to the influencers. Be an influencer.

Moderator: Sunstone Moderators



Creating a Footprint with a Round Pin Array

Postby Sal Hernandez » Mon May 14, 2012 9:30 am

1. With your layout open Select Design New Footprint.

2. Set the grid spacing by pressing the g key on your keyboard to the radius of the circle the pins should fit into.

3. Change the rotation increment by selecting the User Preferences Icon on the tool bar. It will either look like this or depening on the Appearance you have selected. On the General tab set the rotation increment to the angle between pins on this part. Select Apply then OK to save your changes.

4. Place pins at (0,r), (r,0), (0,-r), and (-r,0) where r = radius of the circle.

5. Press esc to return to the Select an object tool. Drag a box around all of the pins to select them. Copy the selection and paste the pins off to the side.

6. Drag a box around the original set of pins to select them and press r on your keyboard to rotate the selection.

7. Go the pins that you pasted off to the side and move them into position. Then paste another copy of the 4 pin array off to the side.

8. Repeat steps 5 - 7 until you have completed your footprint.
Regards,

Sal Hernandez
Software Support Engineer I
Sunstone Circuits
13626 S. Freeman Road
Mulino, OR 97042
Phone: 503-829-9108 x226
Fax: 503-829-5482
User avatar
Sal Hernandez
 
Posts: 396
Joined: Wed Jul 06, 2011 12:00 am



Return to General PCB123 Discussion

Who is online

Users browsing this forum: BipSpign, EletlyRes, FoexFunny, gromarryiz, Hemsbugs, LaliaMayonna, Mocuouppysn, ralphic11, rermavaiday, RufusBrine, ZemCheva and 4 guests

cron